2. The middle layer is the vinyl sticker itself.  

3. The lowest layer is a siliconized paper backing that protects the adhesive layer of the sticker from contamination and damage.  If you need your customed size you can write to us in the mail.

Application Instructions:

----Step 1: Clean surface.  Make sure entire surface you are applying decal to is free of dirt or oils. If you use a sponge or wet cloth, completely dry surface.

----Step 2:  Position decal on wall.  This will ensure that you apply the decal in the desired location.

----Step 3: Prepare the decal.  With the design facing down, slowly peel off backing. IF the decal sticks to the surface of the backing, stop and roll it back a little and try again.

----Step 4: Apply the decal.  Carefully place your design onto the desired location with the sticky side of the transfer tape and the design facing your destination. You can gently rub out any imperfections or bubbles using a credit card. (The more you get the design to stick, the easier it will be to remove the transfer tape).

----Step 5: Remove your transfer tape.

Very slowly, remove the transfer tape from the surface. DO NOT RUSH. As you remove the backing the decal should stick